Discussion Locked
0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have one network already set up. It is in the ip scheme of 192.168.50.120 255.255.255.0. All of the devices on this network are statically assigned. They are plugged into an unmanaged switch behind a cheap linksys router and then plugged into a dsl modem to gain internet access. This IP scheme almost definitely cannot change at this point.I am setting up a backbone right now with fiber that will all be tied together with managed 3com switches. This IP scheme will be 193.0.0.0 - 193.0.1.255 255.255.254.0. This network will have a separate windows server that will be a domain controller, dhcp controller. I want to replace the linksys with a cisco router and link these two networks together. Is there a way of preventing dhcp from traversing across router ports. I don't want dhcp on the 192.168.50.0 network however I want to be able to access devices from 192.168.50.0 to 193.0.0.0. Is this possible?
1 reply
by valavan
There are basically two commands you need to
look at "ip forward-protocol" and "ip helper-
address". If you want the 192.168.50.120
segment to access Windows DHCP, you can use
the command "ip helper-address " on the LAN interface. This will
forward DHCP requests to Windows segment.
If you want to completely block DHCP
forwarding , use the "no ip forward-protocol
53" command , which will block DHCP from
Windows segment reaching the 192.168 segment.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies