Discussion Locked

Cisco PIX 520/ VPN and Cisco VPN Client

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

We are currently in the process of reviewing our
Cisco PIX 520 firewall and its VPN feature.
My question is:

Can we have users at a site with a T1 line for internet connection logon individually like at home using DSL, but instead using the same T1 line to connect to our Cisco PIX 520 with VPN.
The users will have Cisco VPN client installed and configured on each PC/laptop.

Thank You.

5 replies

by acattr

I see you running into a problem. Some dsl routers will only passthru one vpn session at a time. Unless you have external IP's mapped to each individual user.

If you are going to connect multiple users in one location you should have a network to network vpn. Basically a vpn device on the dsl side and your pix 520 on the other. It's easier and smoother.

You dsl provider may be using netopia dsl routers. they have pptp and IPSec built in(documentation at netopia.com). You can also setup a 2000 box with RRAS and use it to do a PPTP vpn.

You can purchase an ethernet netopia 9100 router ($400) if your dsl router is incapable. Or get a cisco pix 506e.

by myamamoto

Thank You for your answer, but this did not help answer the question. There is no DSL, it is a internet T1 line.
They would be running the Cisco VPN client from a internal network out through the internet T1 line and connecting to a Cisco PIX 520 with VPN.
It can probably be done by a site to site VPN or network to network VPN like you sugggested, but again is it possible for each PC with a Cisco VPN client on a internal network using the internet T1 line to access the Cisco PIX 520 VPN site?

by acattr

if there is no firewall on the client side with the internet T1, then you will not have any issues.

If you are running some form of firewall or NAT device, then you may have issues, as some firewalls may only allow 1 vpn passthru session. Hense only one user may use vpn at a time. Check the device documentation on that side.

This discussion is closed to new replies.