Discussion Locked

CISCO Router Question

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Can you have multiple unique DLCI entries on the same subinterface? The routers are 3600's and 2600's running IOS 12.0 and 11.3. The serial interface on the 3600 is a T1 connected to six other fractional T1's connected to the 2600's. How would youget each circuit to work on the same interface that way I don't have to have six different sub interfaces with different IP's. I thought of adding the DLCI's of the 6 other circuits to the same subinterface.

4 replies

by vsergeyev

No problems - You need to create point-to multipoint subinterface :
int s0.1 point-to-multipoint
frame-relay interface dlci 30
frame-relay interface dlci 31
frame-relay interface dlci 35
etc...

by joshg

Thank you but can you change the interface from point-to-point to multipoint, or do I have to create a new subint? I have tried but the router tells me I cannot change the link type. Send me an e-mail

by dc1

Absolutely. Go into config for the interface and issue the frame map XXXXX DLCI XX. Add as many as you have configured.

This discussion is closed to new replies.