Discussion Locked

Cisco routers

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am currently running two Cisco 2524 routers between to branches. They are connected via a T1. Right now these routers are used just for interoffice connectivity. I have another router at the main branch for internet. What do i need to do to be able to used the internet from the remote branch through the t1 to the other cisco router out to mty gateway router. Right now the cisco routers are using RIP.

6 replies

by hotzmiller

There are a few things to do:

Setup a default route on the Remote Branch router so all unknown destinations (like Internet addresses) are sent to the Main Router.
Command: (in config mode) ip default-route (network number of Main Branch)

Thenon the Main Router setup the default Route to the Internet router. Same Command with network number for Internet Router Interface that connects to your ISP.

Finally check your Internet Router for an Access Control List (ACL)that may have been set to allow access only to users in the Main Branch (If your ISP manages the router they will tell you if this has been done and edit it for you). Use the show ip interface command to see if you have any acl's. Use show access-list (in enable mode) to view them. Beware changing an ACL! Get help if you have no experience with acl's and need to change one.

by barry hensley

Step by step.....

1. Make sure the hosts on the branch network are using the branch office router as their default gateway.

2. Set the default route on the branch office router to the IP address of the next downstream router at the main office. (The Serial port at the end of the T1)

3. Set the default route of the branch office router at the main office to be the router connected to the internet. (The ethernet port of the internet router)

4. As long as you have RIP configured properly, the routers will know what to do with both internal traffic and internet traffic. If RIP is not properly configured or you don't want to use it, you will need to configure static routes in ALL 3 Routers so that they all know where to send internal data.

5. As in the previous answer, check the access lists to make sure the hosts on the branch network are not restricted from gaining access to the internet.

When the router at the branch office receives a packet that is unknown to the local network, it will forward it to the branch office router at the main office. When this router receives the packet and does not know what to do with it, it will forward it to the internet router. When the internet router receives the packet and doesnot know what to do with it, it will forward it to the ISP, etc. etc.

When any one of these routers receives a packet from an address that is a part of one of your networks, it will know where to send the packet from the routing table that gets updated using RIP.

by keith g

The routers are also using IP un-numbered to the serial port. I can't figure out the default route command. Everything i read about says use ip default-network. Please explain.

This discussion is closed to new replies.