Discussion Locked

Cisco switch 2970 and 3550 series

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

hi,
i have a wireless DSL directly connected to a cisco 2970 switch, since the DSL router (built-in the antenna) isnt SNMP capable is their a way i can gather bandwidth utilization via switch port level.

thanks,

6 replies

by icb's corner

The Cisco 2970 switch has SNMP. You can use MRTG to gather bandwidth on each port. Also you can use Cisco Network Assistent to manage.

by icb's corner

After you install Perl and make a mrtg.cfg, this program will find all ports of the switch by SNMP.
I had tried for a Cisco Router and MRTG has discovered all active ports.

by jerome

okie ive read the manual w/c was located at cisco.. i was wondering how can i gather traffic on per port basis..

thanks

This discussion is closed to new replies.