Discussion Locked

client/server

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a MS client server and six PC's connected via a LAN, yet whenever I want to access entire network neighbourhood, the response is that there is no accesibilty. What is the simple solution to configure this from my workstation? I am running Windows 95.

9 replies

by conrad

What is the configuration, Is the Server a PDC for an NT domain? Are the workstations logging into the domain? What are the operating systems of the Server and Workstations? Are you running TCP/IP or NetBIOS as your primary protocol. If you are using TCP/IP are you using DHCP? Are you connecting the PCs through a hub or a switch? What speed are the NICs in the PCs configured for?

by Former member

You have to first log into the authoritive network server(Domain) or workgroup. THen be sure your workgroup names are all the same. You may have to load a network logon client if you haven't already...

by crimsoncub

Are they all Win95 machines (including the MS Client Server)? If so, make sure that they all have a common protocol installed. To be able to see other Windows machines in NetNeighbor you must include the NetBIOS protocol.

by srini_soma

You better to configure all the systems with the same workgroup/domain. Use the same protocol (TCP/IP) for all the systems. If it is TCP/IP, use same IP Address order. You will get the connectivity easily.

This discussion is closed to new replies.