Discussion Locked

clients unable to connect to FTP site be

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi all,
I work for a webportal where we have to update the site news regularly. We use NT as our NOS. two days back NT got crashed and then i had to reload the NT. I installed IIS and MS-Proxy 2.0 on the NT server, then what i see is that the clients which are behind proxy are unable to connect to FTP site and if i give them an Public IP they are able to connect to FTP site. Where did i go wrong...
I reinstalled IIS 2.0 and Proxy server 2.0
3 times by now, but no luck till now. Now my three clients (Client meachines) are connected to the net through public ip, and if in case if they need any data from their neighbour systems i again have to change their ip address and bring them in my domain which is just changing their ip address and if i do that they are unable to connect to FTP site. Any suggestions from you guyz or any help might prove very helpfull to me.

Take care.

1 reply

by ntoz

Q209400

To set up an FTP server behind a proxy server:

1. Disable the FTP Publishing service on the proxy server.

2. Install the Winsock Proxy client on the FTP server.

3. Create a file named Wspcfg.ini with the following contents. Place the file in
the same folder as the Inetinfo.exe file on the FTP server.

[inetinfo]
serverbindtcpports=21,20
localbindtcpports=20
killoldsession=1
persistent=1
forcecredentials=1

4. If Access Control is not being used,skip to step 5. If Access Control is
going to be enabled for Winsock on the proxy server, use the Credtool utility
to specify the user credentials.

You cannot set the account as which the service will run in the properties for
the FTP Publishing server (using the Services tool in Control Panel). You can
do this with the Credtool utility. The account you use can be an existing
Microsoft Windows NT domain account or a new one. You just need an account to
use as you do when you are configuring Microsoft Exchange behind a proxy
server.

5. In the Winsock properties on the proxy server, click Add on the Protocols tab
to create a new protocol. Use the following settings:

Protocol Name: FTP Server
Initial Connection: 21 TCP Inbound
Click Add in this dialog box and add the following items:
Port Range: 1025-5000
Type: TCP
Direction: Inbound

6. Enable Packet Filtering and add the following custom filters:

Protocol Direction Local port Remote port
-------------------------------------------------------------
TCP Out 20 Any
TCP In 21 Any
TCP Both Dynamic port (1025-5000) Any

7. After you configure the proxy server, you must obtain and install the hotfix
listed in the following article in the Microsoft Knowledge Base:

This discussion is closed to new replies.