Discussion Locked

cmos setup big problem.

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
my cmos settings have been cleared, I cannot enter setup(key want go through), nor can I access the os. What can I do?

2 replies

by thechas

Slow down a bit and provide a few more details.

As I understand it, either your CMOS battery died, or you cleared your CMOS memory.

The PC does not respond when you press the key to enter BIOS setup.

And, the PC will not boot into Windows.

First, if you lost the CMOS settings, you may need to replace the battery and set the clear CMOS jumper before you are able to recover.

Second, are you using a USB keyboard on a PC with a PS/2 port?
If so, many of these motherboards default to PS/2 only mode when the CMOS is cleared.
You need to use a PS/2 keyboard to enter BIOS setup and enable USB keyboard support.

As far as booting up, what error message are you getting?

No Operating System found.
Insert system disk and press any key to continue.
??

If so, your BIOS is either not seeing your hard drive, or does not have the hard drive in the boot sequence.

If not, post the error messages you see along with a detailed list of your hardware.

Chas

by dmiles

Look on the sides or edges of the Motherboard.
Some manufactures put the jumper next to the CMOS battery.
In some cases, the jumper is found next to the processor fan. However, these jumpers may be to change the processor but not the password.
If you are working on a laptop computer the location of the dipswitch (almost never a jumper) can be under the keyboard or on the bottom of the laptop in a compartment such as the memory compartment.
While it is possible that the jumpers / dipswitches may not be in a visible location, most manufactures try to make things easier by placing the jumpers / dipswitches in another visible location.
Additionally, when looking for the jumper / dipswitch the label of that switch can be anything however in most cases will be labeled CLEAR - CLEAR CMOS - CLR - CLRPWD - PASSWD - PASSWORD - PWD.

Remove the CMOS battery for at least 10 minutes allowing the computer to loose its information. This may not work on all computers.
If your manufacture has a bypass password this can be entered and allow you access to the BIOS and or computer (See BIOS Passwords). Because of the security risk of a bypass password, generally only older computers will have this option.
Locate the CMOS solider beads and jump the solider beads to clear the password.
If one of the above solutions do not clear the password or you are unable to locate the jumpers or solider beads, then contact the computer manufacture for the steps on clearing the computer password.

This discussion is closed to new replies.