Discussion Locked

compaq won't boot

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Have a deskpro, power lite comes on, HDD spins up, monitor shows no displays.

Removed memory and video board, no beeps to show an error.

Compaq had me change the motherboard and riser, simptems the same.

Any sugestins?

5 replies

by jerik

power lights, HDD spinning, and other lights mean little more than the power supply is working.

Follow these steps:

Does the monitor work?
Have you plugged your monitor into another computer to see if it works? or another monitor to your computer?

Have you recently loaded a secondary operating system? Generally if you want linux and windows
install windows then linux because linux comes with nice little prog called LILO.

anyways...

If you've determined that the monitor in fact works then you may have a motherboard problem, but if you've already attempted that route then check your memory.

Are you using SIMMs or DIMMs

If you really don't want to get rid of your computer. Try using a multimeter to check and see if your RAM is still good. I've never had to do this but a completed circuit is still a completed circuit, right.

If you're using SIMMs remember SIMMs must appear in paired banks of the same type.

by mheinze_uk

I had exactly the problem with a deskpro at work. Could not get any beep codes out of it. Get's power and the video was on but nothing. Anyway I had some parts lying around and I tried a new processor, motherboard and psu. It still did the same. I removed the parts and tried another new motherboard and it worked ok. I see a large amount of Compaq parts and it is not unusual to see DOA parts. Good Luck...

This discussion is closed to new replies.