Question Locked

Compaq-XP Pro is frying processors left and right-Any ideas?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an older Compaq EN running XP Pro. Works like a charm as a rule, but lately it fries processors after running around 12 hours.
I had upgraded the processor, the system would not boot at all, simply flashed red lights on the front of the tower. I changed back down in processor number, simply flashed red at me again. I put in the original processor and it ran about 12 hours and then flashed at me in red again, with the system shutting down. I have put another processor to see if this will solve the issue that is lower than the original and noted that the fan on the power supply AND the processsor both do not work. The last orginal processor quit and I noted that the processor area was quite warm and the fan had never turned on. I tried changing the fan, but it never starts either.
I have read other similar issues here on TR, and I noted items about CMOS and Bios flashing. I have done both of those recently, with BIOS flash first followed by CMOS.
What can I do to get the fans to work, I presume the power supply will have to be replaced to get it working, but the Processor fan? Another fan? Another connection? Anything else? I am running out of processors....lol

5 replies

by thechas

Well, if the CPU and power supply fans are not running, that is the problem. Heat destroys processors faster than just about anything.

It is usually easier to replace the power supply than to change out the fan. Most are soldered to the circuit board.

As to the CPU fan, I have seen the power feed to the on-board fan connectors fail. What you may need to do, is use a fan power adapter. These plug into a drive connector and adapt to the fan connector.

I would also verify that the CPU core voltage is being set correctly. What took out the fan power may be causing the core regulator to send the wrong voltage to the CPU.

If you take out one more CPU, you might take that as a sign to replace this system.

Chas

by ctos

Thanks for the great idea Chas! Alternative connection for the cpu fan would definately solve the issue of possable bad connection. I am hoping that is the issue here, rather than the whole board being bad...I will give it a roll as soon as I can get my hands on a fan with an adapter, post back if it solves the issue.
p.s. I have installed the adapter based cpu fan and so far it is running great...but I will keep in mind the other suggestion that possibly the core is sending the wrong voltage to the cpu, thanks Chas!

by inachu

first off make sure you have a decent heatsink.

If you use the heatsink that came with the cpu and you overclock then you are in trouble.
Next make sure you use the best heatsink compound. I reccomend using artic silver.

by tintoman

I would suggest that the PSU failed first, throwing out incorrect voltages here and there, thus causing the CPU to fail, and no doubt blowing a few capacitors on the way, I think by now I would have trashed the PSU, the CPU and the Motherboard!

This discussion is closed to new replies.