14 replies
by ddaniel428
by rcc
Assuming you are still on 98 ground:
Remove all faulty devices, reboot and then it should start finding the removed devices, asking for source files. If it doesn't, force a hardware detection from the control pannel. This should solve any device mix-up.
On the other hand, you need to tell us hopw far down the upgrade track have you been...
Regards,
Radu
by ddaniel428
by shuja52
by ddaniel428
by dmiles
Reference Microsoft knowledgebase article
Q130179,to get solution
by ddaniel428
by fenaikh
Hi
answer 3 is a good answer to start with.
there are 3 situation where you get this:
please do them as listed.
1- You have a virus clean it.Boot clean then
run a virus cleaner.
2-You ahve "noide =1" on your registry delete the entry.
start->run->regeitCtr+f->type "noide" no qutation->delete the entry.
3- your mother board driver need to be reinstalled.Get the lates driver form your vendor then install it.
good luck.
Mohamed
by ddaniel428
by joepoling
I would go to the regestry key "local machine\enum folder and delete it! this is where all of your device setting are held. once this is done reboot and windows 98 will plug and play all of your devices once again, as well as, giving you a chance torestore all of your drivers! the reason that your in compatability mode is probably because your ide controllers on your motherboard have no or incorrect drivers! **before you do this, make sure you have all of your drivers!
good luck!
by ddaniel428
by shuja52
No there are a big difference in NT and WIN9x. The latest upgrade of WIN98 OS is WINME and WINNT is WIN2000. These NT based OS support NTFS but WIN9x series don't..
It is not advisable to upgrade WIN 98 withe WIN NT, ya you can offcourse upgrade WIN98 with WIN 2000 Pro or Server etc..
It is true that WIN 98 is best suited for home PC.
by ddaniel428
by ddaniel428
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending