Discussion Locked

Computer Death?

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Problems started when the mouse froze. Could not do a Crl-Alt-Del, so had to shut it off at the switch. This has happened several times, but computer always came back up, until now. Windows would not complete load and stopped on "Preparing Network Connections" screen. Again, no Crl-Alt-Del, so powered down, it would start to load Windows and stop. In desperation, I removed the CMOS battery, I can get into the Setup but freezes at various times while in Setup; I have tried this several times with the same result. How do I get this thing back up?? Or is it time for a new computer?

Dell OptiPlex GX110
Windows 2000 Pro
Standalone Computer

10 replies

by jkaras

Either the master boot record is corrupt needing repair or my guess would be defective memory. Have you tried another spare stick? Have you tried to reload windows with the repair tool on your 2000 disk? The only other issue might be a defective power supply not delivering a stable amount of power to the rails. Have it tested or buy a replacement and see if it powers up, if not return the power supply. WE used to have those small form factors and they were great work horses at work. ONly issue is the inner parts being proprietary limiting option equipment but holding a spare power supply outside the case is at least possible, then order it from Dell. Hit back with any info you can provide on what you have attempted. Does it always stop on network connections? Could you go into CMOS and disable the onboard nic card to test if it got fried?

by antuck

Since the computer freezes in BIOS I would check all fans to make sure they are spinning. Take some air and blow out any dust inside. Maybe leave the case open and try booting. try also removing any PCI cards, these can cause a system to hang if the are defective or loose. Reseating RAM does it too.

by willcomp

You've already gotten good troubleshooting advice. I would first check RAM and power supply. Try cleaning contacts on memory with a red pencil eraser or pink pearl eraser. Can become corroded and lose contact. Usually fails prior to any display in boot process when that happens though.

If problem is in a proprietary DEll part (especially the motherboard), may be time for a burial service.

Dalton

by steveo

After leaving it for 24 hrs; powered up, display asked to enter SETUP, F2. In setup, hit Esc, Windows loaded! Everything looked back to normal, but as soon so I went to do something, computer completely locks up & no Crl-Alt-Del, had to shutoff power. Does this narrow it down? I'll check memory, fans & PS.

by mjd420nova

It sounds like a bios problem, either not loading completely or is corrupt. The other answers are what I call easter eggs, things I do first before I even power up. Check all memory,
be sure they are seated fully, also check the processor, unmount the heat sink, lift the lever, remove the cpu and then reseat it, and remount the heatsink. Dusting can also be very helpful. GOOD LUCK

This discussion is closed to new replies.