5 replies
by cool&deadly Accepted solution
by jdclyde Accepted solution
If there are not any systems on the LAN that need to be accessed from the WAN, just having the internal systems on a private network will keep your systems fairly safe.
Just deny telnet to your wan interface so no one can log into the router. If you have the webserver access on, deny that as well.
by cg it Accepted solution
to your cable modem? Cisco routers route external traffic through their WAN port, not the ethernet port. The WAN port is a serial port[60 pin]
the default router is ACLs are disabled. If you enable an ACL, there is an implicit deny statement [hidden] where unless specifically allowed, all traffic is denied. However, your Cisco router isn't a firewall. If you want firewall protection, your better bet is getting a hardware firewall like a PIX.
by cool&deadly Accepted solution
by cg it Accepted solution
anything not destined for the LAN is sent to the default gateway if there is no other path specified. The default gateway on Cisco routers is the WAN port which is a serial port.
you could provide a static path out the second ethernet interface, however but if you connect directly to a modem, not a router, that interface is on your ISPs network. That means you have to configure the interface with your public IP address, subnet mask, default gateway and DNS servers.
Might consider getting a WIC interface that will work with your ethernet ISP modem.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending