! If you have no routing enabled
! After the command configure terminal
!(global configuration mode)
Router (config)# ip default-gateway x.x.x.x
! x.x.x.x.
! specifies ip address of
! default gateway router
! you would need to get the address
! of the next hop router on the internet
! from your isp
! Alternately you could
! specify the outbound interface.
See
http://ezinearticles.com/?CCNA-Certification-Training:--Configuring-Static-Routes-On-A-Cisco-Router&id=371788
! The command to use instead of the above
! --if you have routing enabled
RouterM (config)# ip route 0.0.0.0 0.0.0.0 x.x.x.x
! As far as configuring your WAN interface,
! Is it going to be encapsulated in ppp?
! that would be
Router# Configure terminal
Router (config)# interface #
! # is used to indicate
! the # of the interface
Router (config-if)# encapsulation ppp
! You would then need
! at least one permit statement
! What kind of traffic are you planning on?
! just http, https (web), smtp, pop (email)?
! I'd use permit statements
! for each of those
! and for some icmp packet types
! Nothing else will get through then.
!
! As far as configuring vlan1 goes,
! it is configured by default
! (though you do have to say no shut down)
! but it's not secure
! You've got to secure it
! I would secure it before getting it going
! How many switches do you have??