Discussion Locked

Configuring a Cisco router

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

What are the most important steps when confuguring a Cisco routeur, and at each step what command to enter ?

PS.: An example will be fine for me. Pls, don't forge the security aspect.

8 replies

by lanman235

Due to the number of posible router configurations this is an impossible question to answer. I would get a book that talks about basic Cisco configuration and look into the Cisco and Sybex router training simulators available.

by choukri

The most important steps for configuring a Cisco routeur is the security, and the access.
You must enter a systemname : set systemname [name of routeur]
A password : set password system [your password]

Protect local access ( hyperterminal) : set localaccess [protected] [partial] [off]

Protect remote access ( from telnet or other) : set remote access [protected] [partial] [off].

Before you had configured the ip address, subnetmask and other parameter !!

by lashh

I think the real question you should be asking is....This is what I have...and this is what I want to do with it...

Now we can start talking the config.

This discussion is closed to new replies.