Discussion Locked

Configuring NT Workstation as a RAS serv

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am having problems configuring my desktop PC to act as a dial up server using RAS to connect my laptop to my home office.

All my dial out connections seem to be ok and I have configured the port for dial in and out but when I try to connect the desktop PC does not pick up the call.

Help!!

5 replies

by rindi1

this may be a simple question, but what type of modem are you using on the receiving side, activ ISDN? If yes, have you set up the modem for your MSN number? If this number isn't programmed in your modem, it won't pickup a call.

by pc dr.

THIS WORKS FOR ME :
1) Double-click 'My Computer', and double-click 'Dial-Up Networking'. (The 'Dial-Up Networking' dialog box appears.)
2) Click 'Install'. (The 'Files Needed' dialog box appears.)
3) Insert the Windows NT Workstation CD-ROM into the CD-ROM drive.
NOTE: If the 'Windows NT CD-ROM' dialog box appears, click the close button in the upper-right corner to close the dialog box.
4) Type the path to the location of the NT files located on the NT Workstation CD-ROM.
Files needed dialog box
NOTE 1: The files are typically located in D:\i386, where D is the drive letter of the CD-ROM.
NOTE 2: If the files are located somewhere other than the CD-ROM, click 'Browse' to locate them.
5) Click 'OK'. (The 'Add RAS Device'dialog box appears.)
'Add RAS Device' dialog box
6) Select the port that will be used for remote access from the 'RAS Capable Devices' drop-down list box.
NOTE: The list includes installed modems, multiport adapters, ISDN adapters, and X.25 smart cards.
7) (Spe

This discussion is closed to new replies.