Discussion Locked

Configuring Proxy Server 2.0 to use ADSL

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a 4 TP port ADSL router / modem installed and I wish to connect just one of the available 4 ports to my server and use proxy server to give access to the internet to the other 10 PC`s on my network. I have the second network card installed and NT4 is configured to see this card. The existing card has been given the gateway address of the new card but dispite trying various methods I can not ping the internal gateway IP of the router / modem.

Connecting a single PC to one of the available ports on the router works fine. I just can not seem to set up the Server to allow shared access.

I a need a step by step guide on setting this up. Unfortunately my ISP will not support this option and will not advise me.

Any help appreciated.
Thank You

Derek

5 replies

by jasonr

This sounds more like teh proxy isnt configured correctly...

The network card to adsl is not a real card.... it uses a virtual PPP card which you need proxy to see. also appropriate access to "Winsock Proxy" must be set up for internals to go out to the world.

I will post more info once i try this later this week

by delboy

Thanks for the help. But I still can not ping the router / modem gateway IP!

The second network card picks it`s IP from the DHCP enabled router / modem so I still can not figure out what is wrong.

Regards
Derek

by stillatit

Step 1. Make sure your NT box, without proxy, can ping the net. If this does not work, nothing else will. Take out the gateway address on the LAN card. Your "net" NIC should have an IP address in the same subnet as the router (which might be via DHCP depending on your router and its setup), and should have the router as its gateway address. Make sure its subnet mask is correct.

Step 2. Install and configure Proxy Server. In particular, identify which NIC is the internet side. For now, turn off all filtering and restrictions (this is the default). I believe that the gateway on your LAN side should be blank, but check the directions.

Step 3. Make sure you can still get to the internet from the NT server.

Step 4. From another station, make sure that the NT server LAN card address is the station's default gateway, make sure TCP/IP is properly configured, then try a ping to a known-good internet address. If that works, repeat on other stations. If not, keep going.

Step 5. Double-check that TCP/IP on the station is working:
Ping 127.0.0.1
Ping the station's own address
Ping the NT server.

Step 6. If you get here, Proxy is not working correctly. Check the following:
IP routing is turned off.
IP Proxy is turned on.
Proxy service is running.
All event log entries relating to proxy.

by scott.fuhriman

I have done this many times and have lots of experience setting up both Proxy and DSL on networks.

The first item to understand is that when a computer is plugged into the DSL router directly, the PC is probably picking up a DHCP request from therouter and that is why it can connect when plugged in directly.

The most important thing to remember when you are utilizing two network cards in an NT server is that you need to configure it properly for multi-homed use. If you haven't done thisalready, then you need to open the TCP/IP properties on the NT server and select the last tab which will enable "IP forwarding". What this does is turns your NT server into a router so that packets can go back and forth between the two NICs which should be configured as seperate networks by their IP configurations.

Once, this is done then you need to check that the server can browse the Internet. When you get it configured so that the server can browse, then your PC will be able to browse - assuming that the clients are configured to use the proxy server "http://servername" Port "80"

There is a lot of information that is hard to fit into the 1930 character limit, so I hope this has helped.

This discussion is closed to new replies.