Discussion Locked

Configuring two graphics adapters in Lin

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Is it possible to configure two graphics adapters in Linux? The first one is an on-board VGA chipset and the second is an RG101 PCI graphics adapter.

5 replies

by linuxian

You can have multiple cards with Linux but it requires a 3rd party X-Server. I use metrolink to run 4-head Matrox Millennium cards on our Linux engineering stations. Running multiple monitors uses a huge amount of memory so don’t get too silly with 32 MB of RAM or anything like that. You can find a list of compatible multi-card-format cards at http://www.metrolink.com/productindex.html

The only problem is that separate cards (your config) vs. multi-head cards is that separate cards are a bit more difficult to work with than multi head cards because you have two separate devices accessing the PCI bus to do the same thing. Resource sharing isn’t a Linux strong point.

Good Luck

by jgluck

This is dependant on how much trouble you want to go to...

I assume you want this config in X windows.
If that's the case you can go over to http://www.XFree86.org and download release 4
after checking if it has the drivers you need.

You canalso uuse the 2.4 kernel that also has multihead support in the kernel. That will require upgradeing quite a few of your other packages.

The final option is to get a commercial xserver like MetroX.

This discussion is closed to new replies.