Discussion Locked

Connecting 10/100 hubs

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I currently have (2) 10 base T hubs connected by BNC/Coax line. They are more than 100 meters apart. If I upgrade my system to a 10/100 Base T system how will I connect those two hubs.

7 replies

by dlafrombois

This is simple. Purchase two 10/100Base-T to 10Base-2 transceivers. This will enable you to use the current BNC/Coax cable you are already using with the newer hubs. Plug each 10/100 base-T into the new hubs and connect the coax into the transcievers. You may need to use "ROLL OVER" or "Cross over" network cables.

Good Luck

by tbradley

answer 1 seems the cheapest and easiest
solution. Make sure you buy media
converters with built in MDI/MDIX so you
won't have to worry about the hubs having
a "crossover" port.

by nskharade

I dont agree with the answers. From my point of view,along with the two 10/100 hubs, buy a repeater which supports 10/100 Mbps speed. Connect the repeater in between the two hubs. This will also be effective in the long run if u plan to upgrade yoursystem to 100 Mbps.

by dwbjr

Is there any particular model you use or would suggest i look at.
Thanks!!

This discussion is closed to new replies.