Discussion Locked

Connecting 2 ISDN routers together...

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Has anyone had any success connecting two ISDN TE1 devices(Cisco 1604) to eachother? It may not even be possible, but I hate to see those ports sitting there doing nothing. Thanks.

5 replies

by barry hensley

Yes, you can. There is a special cable made that has the serial connector on each end that matches the Cisco interface.

Make sure you set the port speed the same on both routers. The link will be a LAN of it's own so, you can either use an off-net ip address range with a .252 subnet address or, you can map the serial ports of each router to the ethernet port using the unnumbered feature.

by cisco_guy

Are you referring to connecting them via serial ports? I want to connect them via their BRI ports with a patch cable. This is what I'm not sure is possible.

by mckaytech

In my humble opinion, the short answer is no, it's not possible.

An ISDN device is an interface to a Central Office switch and is only capable of negotiating a connection to that switch and not with another ISDN device.

Sometimes ports need to just sit there... :-)

paul

by cisco_guy

Unfortunately, I'll have to except that answer. =) I really hate to see those ports sit there though!

This discussion is closed to new replies.