Discussion Locked
0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have two networks in an office that do differeent jobs , one is a lan via isp with internet connection while the other is via a router (cisco) and phone line while the other is via a wireless system , now the network that is configured via the router then a hub does not have internet connection while i would like to link the two so that i use the isp getway , how do i go about it, do i run a cable from one of the hubs to individual computers then add a nic card in the computers that is they will have two nic that is an extra cost or run a crossover cable from one hub to the other hub and create additional getway or what do i do , I am stack what do i do , i would be glad to receive assistance.
1 reply
by daimon
Couldn't you using one of your hubs set the little button on the back that changes port #1 to an uplink, ie it makes it suitable to connect 2 hubs together via a standard cable. Without seeing a full layout I wouldn't be able to make any more recommendations.
Your description however makes it look like 3 networks, one using lan to ISP, one using a phoneline + cisco router, and one using a wireless system. Could you clarify this a little more?
What sort of network hubs are you using ? (number of ports/make/model)
What sort of network are you running and what are they running the same OSes on both networks?
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies