Discussion Locked

Connecting fiber with switches

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I had a linksys switch,16 port ethernet, 2 port fiber optic go bad. When I went to replace it they say they don't make 2 port fiber with ethernet anymore, only 1 port. The only ones I can get cost about $2000.00. Any ideas?
I tried taking two switches that had 1 fiber port each. I connected fiber to one and then a cat 5 to the other then out with fiber on the second. I get blinking lights but the fiber led on one switch is dull and I can't see my network on that side. Anyway that's the story any ideas would be greatly appreciated.
thanks Lynn

3 replies

by ayoshi

I would get a fiber optic/RJ45 transceiver adapter and plug it into a Cat 5 port on the switch.

Linksys should have these available, or you might even be able to get one off the shelf at a computer superstore.

by rhodking2

Go to blackbox or anixter's website and look for a fibertwist transceiver (fiber to twisted pair) or media convertor is another name for it. They may have a device that has a two fiber uplink switch that is less expensive. Make sure you get the right fiber connectors and link speed that you need. Also, regarding connecting the two fiber switches...I think your cat5 connection between switches may need to be a xover cable (pins 1-3 and 2-6). You may need to just roll the fiber on the end that is dull (tx to rx, rx to tx, etc.). I hope this helps.

This discussion is closed to new replies.