Discussion Locked

connecting IP thru DOS

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Recently purchased a Linksys EtherFast 10/100 20GB GigaDrive I have a couple of DOS PC that need to access it thru IP. It's been so long since I've worked with DOS any one remember/know how to connect to an TCP/IP network with dos.

6 replies

by gareth chapman

Are these dos only PCs? It has been awhile but, I think you have to install an IP Protocol Stack. The "Chameleon" program used to do a fairly good job with Dos/Win3.x, but there were other programs that worked too. Hope this points you in the right direction.

by jmiller

yes they are dos only pc tried an old copy of Chameleon couldn't get it to work, it did load ip but would not let me access drive.
thanks

by white wolf

Well, to be short and to the point (like your question), you can get a dos w/s onto a novell network by downloading the 2.71 client for dos from http://www.novell.com/download/#Clients - Network
and installing it. You just have specify you want itset up with IP protocol (you'll need to either manually assign your w/s IP address, or have it get it dynamically from a DHCP server). That should do it.

by jmiller

thanks Tim was not trying to connect to a novell server was trying to connect to NT. NT. has a DOS client and worked great for what I needed. thanks again for a point in the right direction.
Jim

by gaplid

I have try to connect my dos workstation with netware software thru IP . There is NWIP server included with netware server. Just setup the software. They use DSS server too.
You can use bootp too, it's simple program with little configuration

This discussion is closed to new replies.