Discussion Locked

Connecting ISDN Router to network

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a ISDN Router that is connected to our network, it is also the DHCP for the network. Can I go from the router to a NIC in the server and allow the server to provied the DHCP service and another NIC to the network via a switch? If so what settings should the sever have running other then DHCP? I think right now if I turned the server off everyone still has access to the Internet.

3 replies

by shanghai sam

If I understand your question correctly, you want to place the server between the router and the network.

If this is the case you should configure the server's NIC's with two IP addresses from two different subnets and configure some way of routing on the server and enable IP forwarding. One subnet will be you normal network, the other one the link between the server and the router.
You should configure the routing of the server to send all traffic destined for the network on the other side of the ISDN connection to the ethernet interface of the router.

You should disable DHCP on the router and install DHCP server software on the server to provide systems on the network with IP addresses. Also all the systems on the network should be configured to use the server as gateway.

Hope my info helps a bit.

to read some more info about routing, internetworking and LAN/WAN technology see:

http://www.cisco.com/univercd/cc/td/doc/cisintwk/ito_doc/index.htm

regards,
Ger

This discussion is closed to new replies.