Question Locked

Connecting Linksys RE6300 Extender with Linksys router

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I want to connect a Linksys RE6300 network extender to my Linksys router on my home network. I reset the extender and it's plugged into the wall outlet and I got it to get an IP from my router's DHCP service, I can see the extender in the router DHCP table. But when I put the extender upstairs and I have a CAT5 cable run to it from the home network, extender setup as an Access Point, I am not getting any wifi signal off the extender when I'm 5 feet from it. What else needs to be setup in the extender to get it to work?

2 replies

by harrymr672

Thanks for the discussion — this is a great thread for people trying to get their extenders working properly. When connecting a Linksys RE6300 to your main Linksys router, make sure you’re using the same SSID and password, and position the extender within good range of the router (not too close, not too far). Also check that both devices are set to compatible wireless modes (e.g., both on 2.4 GHz or using mixed mode), and update the firmware on each device if possible newer firmware often fixes connectivity quirks. Hope this helps and that you get it up and running smoothly!

This discussion is closed to new replies.