Question Locked

Connecting to a cisco router with windows vista

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi all.

Am currently studying for my CCNA and have been given a Cisco router to play with. However, I am having a real struggle connecting to it. I do not know the IP address od the router and cannot seem to find it anywhere...
I have the router connected to my pc via a USB to sereal adaptor.

Any advice will help

3 replies

by cg it

an address but if your studing for your CCNA you should know that.

if your using a USB to seral adapter what's that connecting to? your text books for CCNA would have the "how to" connect to a router in it. Least all the text books I've read do.

Maybe check out Amazon.com and get Todd Lammle's books for CCNA.

by radika01

Hi. Pls follow these steps to configure ur router- hope u're working with XP.
1-power on ur pc

2-make sure ur router is powered off!
connect ur router to ur pc: use a serial cable with rj-45 to db15 ends(this cld be that blue cable that came with ur router)

3- the rj-45 end goes into ur router's consle port(marked blue); the db15 end goes into the COM port behind ur pc

4-go to start/
all programs/accessories/communications/
hyperterminal

5-click on the hyperterminal program; enter a name and icon for ur connection

6-Enter ur port settings:
bits/sec-9600
data bits-8
parity-none
stop bits-1
flow control-none
OK

7-now power on ur router and wait 4 it to boot completely into hyperterminal! u'll knw this when u get the router> prompt.

ENJOY UR CONFIG!

This discussion is closed to new replies.