It specifically says:
[i]Description
Link aggregation is designed to overcome two problems with Ethernet connections: bandwidth limitations and lack of redundancy.
The first issue is that bandwidth requirements do not scale linearly. Ethernet bandwidths historically have increased by an order of magnitude each generation (10 Megabit/s, 100 Mbit/s, 1000 Mbit/s, 10000 Mbit/s). If one started to bump into bandwidth ceilings, then the only option was to move to the next generation which could be cost prohibitive. An alternative solution, introduced by many of the network manufacturers in the early 1990s, is to combine two physical Ethernet links into one logical link via channel bonding. [b]Most of these solutions required manual configuration and identical equipment on both sides of the aggregation.[/b]
The second problem is that there are three single point of failures in a typical port-cable-port connection. In either the usual computer-to-switch or in a switch-to-switch configuration, the cable itself or either of the ports the cable is plugged into can fail. Multiple physical connections can be made, but many of the higher level protocols were not designed to failover completely seamlessly.[/i]
Furthermore, it says
[i]Limitations
Single switch
A limitation of link aggregation is that all physical ports in the link aggregation group must reside on the same logical switch which in most scenarios will leave a single point of failure when the physical switch to which both links are connected goes offline.
[b]However, this can be overcome by using [u]vendor-specific extensions[/u] which aggregate multiple physical switches into one logical switch.[/b] As of 2009, the IEEE has not yet committed resources to standardize this feature.[/i]