Question Locked

Constantly reloading Cisco 2811 Router

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi, I have this 2811 router which runs 4 E1 connections bundled as a single Multilink for internet purposes. When the internet suddenly goes slow, I am forced to restart this edge router, thus causing downtime for our internet connection. The thing is, no problems or errors were detected on the router except that when we do a trace route, our next hope takes >600 ms. Normally this would be less than 10 ms. I am unable to pinpoint where the problem might be as the interfaces and SNMP do not detect any issues. No buffer failures or misses. Is there something that I'm missing that could be the cause of this? This is starting to happen on a daily basis and I have no clue what to tell our users about it. But yes, restarting the router does solve the issue. Appreciate any insight into this.

Thanks!

3 replies

by synner

Does the multilink interface go down?

by wabukisensei

It doesn't go down, more like the link slows to a crawl. Funny thing is that my ISP is saying that they're receiving a lot of traffic from my end, but I see nothing on my end that would cause high traffic.

This discussion is closed to new replies.