Discussion Locked

Cursor out of Control

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

As I type while on the Internet, I lose control of the cursor completely. It slides slowly across the screen from bottom left to the middle top of the screen and then slides across the top of the screen to the right corner. I have no control until it finishes this cycle.

I have looked at "mouse" settings under "control panel", but don't see anything unusual. I've also scanned with Microfoft Anti-spy, Adaware and Norton Internet Security without any effect.

7 replies

by electricdragon

Hi-
I had a mouse that did the same thing, I cleaned it top to bottom and it didn't help a bit. My only answer was to plug in a new mouse, worked fine after that.
Only other chance is to skip the driver that comes with windows, and go to the website of whoever made your mouse and get a driver there if they have one. might help, might not.
Cheers,
ED.

by electricdragon

Hi again-
I just read your comment from 1-25 and I have a suggestion.
replacing the keyboard and weenie mouse/touchpad may be an easier option than you might think. I've never taken a Dell laptop apart, but the keyboards on laptops usually pop out rather easy.
That said, though I'm not sure what model you have, I got over 600 hits from an eBay search, and most look fairly inexpensive. (looks like about $10-$30)
Link:
http://computers.search.ebay.com/dell_Keyboards-for-Laptops_W0QQcatrefZC12QQfrppZ50QQfsooZ1QQfsopZ1QQmaxrecordsreturnedZ300QQsacatZ51153
Just a thought, but before you buy one try cleaning the contacts on the ribbon cable coming from the keyboard, I have seen oxidation cause problems there, use rubbing alcohol and a lintless cloth.(and be very carefull lol)
ED

by mjd420nova

First try plugging in an external mouse
if that works okay, as the system should
sense the new hardware, then the little
touch pad may be dirty or have something
wrong on on of the chips that drive the
pads sensors. Complete dis-assembly is
called for and usually ends up in the
replacement anyway. Not an easy job and
a stockpile of plastic parts needs to be
available as they are not easy to get apart
without screwing up the plastic. Purely
cosmetic however.

by w2ktechman

Disable the mouse in the BIOS (if available)
Plug in an external mouse. Does this work? If so, the notebook needs maintenance (probably a replaced keyboard which usually houses the mouse controller)

by gary56789

Make sure a USB mouse works (so you have control), then download the touchpad drivers, uninstall the current touchpad drivers and reinstall the drivers from the newly downloaded files.

This discussion is closed to new replies.