Question Locked

Custom Papersize on matrix printer

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I program to print a cheque book.. i set printdocument papersize to 3 inch height and 8 inch width with new papersize constructor.. it works finly in printpreview dialog but when i try to print it, it does not print correctly as preview control.. it print one cheque book and throw whole single page as printer default papersize in set as A4.. how can i set printer default papersize to custom.. i am using vb.net.. thanks in advance for your support.

4 replies

by leirags

First at all, you must know the dot matix printers need to know the paper size but this are done on the printer setup, (almost all times i did on this way) you cannot mix setups but some kind of printers have macros inside.

I use tgis brands of printers: Okidata, startmicronics, panasonic.

I recomend a Okidata but this depends on you.

Read a printers manuals because thinks change over the time.

Above the paper feed, always the page end with a #12 -> form feed then the printer need to know the size. Okidata have a severals sizes for you.

by dibya.shakya

I too have the problem regarding printing a cheque book.. in my finance siftware i set printdocument papersize to 3 inch height and 8 inch width with new papersize constructor..

for this go to
1. control panel of your desktop where u had installed matrix printer
2. if printer not installed, installed it first.
3. Start/Settings/Control Panel:

Printer & Other Hardware/Printers & Faxes/

File(on the top toolbar)/Server Properties/Click the 'Forms' tab and take it

from there.

I think you got the solultion.

If success mail me in following address.
dibyatarashak@yahoo.com

thankyou

by dibya.shakya

to
sanjannya@....

I too have the problem regarding printing a cheque book.. in my finance siftware i set printdocument papersize to 3 inch height and 8 inch width with new papersize constructor..

for this go to
1. control panel of your desktop where u had installed matrix printer
2. if printer not installed, installed it first.
3. Start/Settings/Control Panel:

Printer & Other Hardware/Printers & Faxes/

File(on the top toolbar)/Server Properties/Click the 'Forms' tab and take it

from there.

I think you got the solultion.

If success mail me in following address.
dibyatarashak@yahoo.com

thankyou

dibya

This discussion is closed to new replies.