10 replies
by gary56789
First, suspect a malfunctioning power supply. The easiest way to check this is either borrow (or buy) one and try it. The other way is to test it with a VOM (if you are handy and know the correct procedure and voltages used for your system). Be sure to ground your self and not to touch any metal connectors inside the case.
Next, check memory. If you have two chips, usually one will be good. Try each by itself in the first memory slot (remove all add-in cards except video when checking memory).
Other problems could be the CPU, an add-on card or MB.
by winikeh
by sue t
by dfornet
I agree with the other posts, but lets take this one step further. After checking the p/s, and discharging the power button, try disonnecting the internal devices one at a time (hard drive, cd-rom, etc) by unplugging the power. Also if you have a low profile system that uses a riser card for the add-in cards, remove that and try to power on. Those are notorious for going south.
As far as checking the voltage of your power supply, most p/s's produce +/- 5v dc and +/- 12v dc to run the peripherals. And the LED on the system board would indicate that you are getting +5v dc to the system board.
by dfornet
I agree with the other posts, but lets take this one step further. After checking the p/s, and discharging the power button, try disonnecting the internal devices one at a time (hard drive, cd-rom, etc) by unplugging the power. Also if you have a low profile system that uses a riser card for the add-in cards, remove that and try to power on. Those are notorious for going south.
As far as checking the voltage of your power supply, most p/s's produce +/- 5v dc and +/- 12v dc to run the peripherals. And the LED on the system board would indicate that you are getting +5v dc to the system board.
by hnhwc
by hnhwc
Hello there;
As you know, the Computer upon start-up, will do a series of self checks.
I read here that it goes through the process and then stops cold, i.e. it won't even read the Hard Drive.
As I would go through the process mentioned earlier, Make sure your connections are all ok, "Especially" the Yellow [12 Volt} part as they tend to weaken and sometimes can't read right.
Then I would clear the CMOS.
Once you've done that, try it, still the same?
Now it's time for the Ram Tests. Hopefully you have more than one, just take them out, one at a time, the system will start, but it will be slow, then invert the process. It could also be that you added Ram and perhaps didn't re-adjust your Voltage? i.e. 3.3volts to 5 As a last resort, I would switch hard drives if you can.
The system is not completing it's cycle and that's why it stops. Trick is to find out what is stopping it.
I'm willing to bet Hard Drive or Ram, but you won't know that until you've tried all the tests, sorry.
I would definitely Clear out the CMOS, as it may be trying an old boot and you need a clean boot.
If you can get into the BIOS setup, load setup defaults and go from there.
I'm going to give this a little more thought.
Regards
Aaron
Good luck.
by wbs_aus
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending