Discussion Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I stop Dec Mop multicasts from a Xyplex Access Server 720?
2 replies
by buntingjim
The DEC Maintenance Operation Protocol (MOP) is most likely due to your Xyplex 720 being incorrectly configured to Support one of the following protocols - DECnet which is a propiatary Multicast (AA/AB) protocol, or the DEC Local Area Transport (LAT) Protocol.
As with most network supported peripheral devices, such as network Printers, they are shipped from the factory with a default setting enabled for each of the supported protocols.
Check with Xyplex for product specific configuration procedures, and disable any network protocol that is unnecessary.
by shanghai sam
My question was "How do I stop the multicasts?" Of course the 720 is incorrectly configured. How do I configure it correctly? "RTFM" is the obvious answer but the "manuals" aren't much help.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies