Software
I upgraded the ram on my Dell Dim 4300s from 133mhz to 1gb (2 512mb). When I turn the PC on all it does is beep and the monitor shows no signal.Software is windows XP
I think it beeps 3 or 4 times then repeats
Thanks 4 for help, This is the PC my special ed students use :(
Green
by ksgmitchell Accepted solution
by ic-it Accepted solution
The manual claims you can use a 512MB (133MHz) module, two slots available, but a max of 512MB.
Try removing one module (also verify that the other is in the slot properly.
The beep code indicates memory problem.
http://support.dell.com/support/edocs/systems/dim4300s/codes.htm#1101572
by robo_dev Accepted solution
by robo_dev Accepted solution
So it should work fine with one memory stick.
http://support.dell.com/support/edocs/systems/dim4300/specs.htm#1102880
Architecture
SDRAM PC133
Memory capacities
64-, 128-, 256-, and 512-MB non-ECC or ECC SDRAM
Maximum memory
512 MB
Memory type
PC133 (non-ECC or ECC)
by nhcs Accepted solution
I don't know how I ended up doing this or what made me think it would work, but I have 1gig of RAM in my 4300s and it has been running happily this way for a few years.
FWIW!
This discussion is closed to new replies.
Sort by Trending