Question Locked

Dell Inspiron 6000 LCD issues

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Dell Inspiron 6000 that has LCD issues, at first when you booted it up the screen would flash on with a red tint, then go off. I replace the inverter and that didn't work same thing, I then replaced the backlight, " that was fun " now when I boot up it comes up bright but after like 30 seconds goes really dim again, you can see the desktop with a flashlight. If i use an external monitor it works just fine. Would this be the LCD it's self or motherboard ? I'm confused at this point.

9 replies

by mjd420nova

This is a classic failure of the LCD element itself. If you've replaced the backlight you'll find replacing the element itself pretty easy. If it's outside of warranty, which I suspect it is, they run around $200. for the replacement part from Dell.

by mjd420nova

Yes. the flat panel that actually diplays the colors, not to be confused with the backlight panel that goes behind it.

by ggoldsm590

So the bad LCD element will cause the backlight to go off and make the screen so dim you can only see it with a flash light?
I really appriciate your assistance with this

by nbolds442

I was wondering if you fixed this issue because I am having the same problem. I think mine might be the cable because I was twisting it a little while it was on and the screen would come back then go out again, but any info you have would be nice

Thanks

by gkervill

My Inspiron 6000 has behaved the same.
Pink tint - clearing after a few seconds.

Now I have no display at all - the CLONE DISPLAY worked (took more than an hour viewing the blacked out display with a flash ;amp and magnifying glass). So it is usable.

When I view properties I sometimes get the Windows options - other times I get the Intel version?????

The external monitor is identified as "1" - display "2" is not bolded. When I access the Windows properties display 2"2 (notebook?) reports the the display in "Not Active".

Bios looks ok - my gut feel is it is a driver or 'soft switch' issue.

I don't think is it a hardware failure because the Notebook display flashes during POST.

I updated the Dell Diagnostics - that did not find any errors.

I'm now very confused - comments and suggestions welcome.

Gregg gk9@Kervill.com

by chucksterk315

Hello, it seems that you need to replace your inverter which is a component in laptop computers that supplies the power to provide a backlight to the monitor, enabling the user to view what's on the screen.

by chucksterk315

In your post, u said there are no display but using a clone device work. The problem is that your Laptop screen need to be replace with a new Inverter. The inverter is a component in laptops that supplies the power to provide the backlight to the monitor, enabling the user to view what's on the screen. If you need steps on how to replace it just put a new post.

This discussion is closed to new replies.