Discussion Locked

Dell notebook

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have A refurbished Dell Latitude cpi notebook with no OS installed on it. Using windows 98 boot disk to reinstall windows 98, the problem I'm having is using the boot disk you need to use the floppy drive when it
comes to where boot disk loads the drivers for the CD-ROM,the CD-ROM can not be found because you can only have the floppy drive. When you go and switch to the CD-ROM it says D: Can not be found
which is the CD-ROM.How can i get the CD-ROM to run in DOS so I can install windows?

14 replies

by Member 33712138

You might need a specific boot disk for that laptop. A normal boot disk has drivers for standard floppys & CD ROM's. Not PCMCIA versions. Goto Dell's site & see if you can download one.

by nannig3

I only have the normal boot disk that has drivers for standard floppys & CD ROM's.I checked Dell web site did not see one for PCMCIA versions.

by joe

Did you try to change the bios to boot from CD first? It's worth a try When computer is starting look for the key to setup. Could be DEL or F2. Good luck

by nannig3

I did go in to the bios to have it boot to the cd-rom first, then hard drive no luck.

by dcosgrove

Dell makes a cable for the floppy to work with the parallel port. They sell them on the Dell website for approx. 15.00. You may want one in the future anyway.

by fazal

1st You will need a bootable ver of windows 98,
2nd you need to change the boot from option in bios to CD-ROM, hit F2 or Alt+Ctlr+Enter to enter setup

That should do it!
Good Luck!

by maddiuex

first, if you are formatting the hardrive, you can run setup from c:\windows\options\cabs\setup.exe

If you are, Build the boot sequence
1. you will need on the hardrive IO.sys, Msdos.sys, so from a a:\prompt type A:\>SYS C:
2. then you need to copy all the files from the diskette to the HD
3. Then you can edit the autoexec.bat file and anything that starts with A: rplace the a with c
4. do the same for the config.sys.

Hope this helps?

This discussion is closed to new replies.