Discussion Locked

Dell Opttiplex No Port for Modem

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We have a small computer shop and buy used off lease equipment...
Dell Optiplex system does see a PCI or ISA modem with Comm ports set to COMM 1, COMM2 in bios or AUTO in bios settings.
Installed both PCI WIn Modems and ISA USR
Any Ideas
Aready tried Dell Web Site

9 replies

by paulote

it looks like you have to disable the com2 in the bios to make the modem operative because if the modem use the irq4, the com2 uses the same resource...

Paulo

by frank.duffey

Aready tried disable on Comm 2 in bios setup seems to not read the daughter board at all in the system it is a P-166.

by mpdcsup

Completely disable the serial ports on the system (via BIOS Setup). If you're using a PCI adapter, make sure IRQ 3 and IRQ 4 and I/O addresses 3F8-3FF and 2F8-2FF are *not* restricted from use by the PCI bus (also via BIOS Setup). If you're using an ISA adapter make sure that IRQ 3 and IRQ 4 and I/O addresses 3F8-3FF and 2F8-2FF *are* available for use by the ISA bus (restricted from use by PCI).

Remember, when you're adding adapter hardware (don't confuse issues -- this isn't a daughter board) to disable onboard resources that provide the same function.

by csmith

The only way cheap way around this problem.
Use cheap internal PCI Wintel modems.
Leave COM1 and COM2 enabled.
Force MODEM to COM3.
(Using I/O 200h sometimes is necessary.)
Regards, Chris

This discussion is closed to new replies.