Question Locked

Designing a network , NIC card

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

1. NICs can tell whether an arriving frame is tagged or not simply by looking at it. How can they do so? (Hint: They look at the value in the two octets following the address fields.
2. You will create a design for a network connecting four buildings in an industrial park. Hand in a picture showing your network. There will be a core switch in each building.
? Building A is the headquarters building.
? Building B is 85 meters south and 90 meters east of the headquarters building.
? Building C is 150 meters south of the headquarters building.
? Building D is 60 meters west of Building C.
? Computers in Building A need to communicate with computers in Building B at 60 Mbps.
? Computers in Building A need to be able to communicate with computers in Building C at 300 Mbps.
? Computers in Building A must communicate with computers in Building D at 50 Mbps.
? Computers in Building C must communicate with computers in Building D at 75 Mbps.
? Building A will connect directly to Buildings B and C.
? Building C will connect directly to Building D.

a) Specify the standard you will use to connect Building A to Building B.
b) Specify the standard you will use to connect Building A to Building C.
c) Specify the standard you will use to connect Building C to Building D.
The distance is only 75 meters, so UTP is fine. The combined traffic is 125 Mbps (75 Mbps from C to D and 50 Mbps from A to D). With link aggregation, two 100BASE-TX trunk lines would do the job at minimum cost.

1 reply

This discussion is closed to new replies.