Designing Leased Line Connection
I want to setup a leased line (128Kbps). Can you help me decide what kind of CISCO router will I use? What areas/concerns will I have to consider?
Networks
I want to setup a leased line (128Kbps). Can you help me decide what kind of CISCO router will I use? What areas/concerns will I have to consider?
by nsantos
by lomex
To help you with your problem,
CISCO Routers will work 2500's, 1700's and 2600's.
These differ models differ from one another according to
No. of WAN ports,
No. of ISDN ports,
No. of Ethernet Ports, Token ring ports
No. of Async Ports etc.
For the 2500 Family all ports are fixed meaning what u see is what u can get.
ex 2501, 2506
For the 1700's and 2600's the boxes come balnk slots where u have the option
what you may put in. Modules like 1-port WAN, 2-port WAN or 1-Aync etc.
The 1700 family and 2600 family have also built in ports. Call Datacraft for further details.
by wlbowers
There are two types of leased line. Fixed:
This is a dedicated pair or wires from
point a to b. Shared Slick: {my pet name}
This is where a provider will take your
data and shove it into a DS3 pipeline with
a whole bunch of other folks. If you use
the fixed method then you have total
control of everything between points.
Anything the lines will handle and the
equipment can do is yours.
The Shared Slick as I call it will come with
some restrictions. You will have a
bandwidth { 128k for instance} and a
CIR. { 64k for instance} {CIR = Committed
Information Rate}. This is the largest
packet of information that is guaranteed
to be transferred without being broken up.
Now depending on what you plan to send
down the pipe this can be a good thing or
a very bad thing. If you plan to use this for
Voip. {Voice Over IP}. Breakups will cause
voice quality to suffer.
When you deal with a vendor be sure that
you have a good understanding of the
base bandwidth and the CIR of your line.
If you decide that you want 128k with a cir
of 64k. Request that a full t1 be pulled in
to the facilities. That way if you need to
increase bandwidth then the vendors
hardware is there and they only have to
make some computer entries.
Both answer 1 and 2 agree with me with
Cisco equipment. They have the largest
assortment of equipment and software
combinations you can get. Maybe this is
why most of the Internet travels on their
equipment.{ before the wolves come out I
said most}.
I would recommend the 2600 routers. I
have used the 1750's and they are fine
except for several problems related to a
reload or cold boot. The 2600 doesn't
have this problem there are more
software configurations with a wider
range of options for the 2600. As one of
the other answers states you will have to
configure the router with plug in cards.
You can contact
This discussion is closed to new replies.
Sort by Trending