8 replies
by curlergirl
by battallion14
by mckaytech
I'm not absolutely clear what your setup is but I assume that one NIC goes to the 675 DSL router and the other goes to a home network.
To answer your question, yes it is possible to use both DHCP and static addressing. Go to Control Panel-Network-Protocols. Highlight TCP/IP, then Properties. On this page, you will be able to select the NIC and set the properties for that NIC so you could leave the DSL NIC the way it is and set the other NIC to a static private IP address of your choosing.
Sharing the Internet connection with the home network is whole 'nother story but can be done several different ways and I'd be glad to comment on that as well.
regards!
paul
by battallion14
by dyeager
1) both Nics in NT, multiple pc access to internet
Give both Nics private addresses, i.e.: 10.1.1.1 and 10.1.2.1, with masks of 255.255.255.0. Give router address of 10.1.1.2, which should be gateway for 10.1.1.1 nic in NT. IP forwarding should be enabled in NT to allow a pc on 10.1.2 segment to go out to internet. Static or dhcp gateway for 10.1.2 segment should be 10.1.2.1, which routes to 10.1.1.2 to internet.
Enable NAT in 675:
cbos# set nat enabled
cbos# write
cbos# reboot
DHCP on NT needs ranges for both segments. Errors may come from a conflict with DHCP in 675, which defaults to being a DHCP server
2) Have only server access internet
set internet nic card to dhcp, enable 675 only as a bridge, put static addresson other card with private address, enable dhcp on server with addresses only for private address segment.
3) one Nic in NT, another in different pc.
Use only 10.1.1 range in both pcs. Disabling DHCP in NT preferred -- it could be off and second pc could still ac
by battallion14
No need for a second NIC.
I'm using a cisco 675 on a dsl hookup. I assigned a static ip address to my PDC within the 10.0.0.0 range. This is the same range the DHCP is using. Since the DHCP uses 10.0.0.1 by default, setting the PDC to a static ip address higher than the anticipated number of clients the DHCP will connect with I avoided a conflict.
For those skeptics out there, this has been working fine for the past 4 months.
by battallion14
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending