Discussion Locked

DHCP assign IP to client in other subnet

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I configure a NT DHCP server to assign IP to client in different subnet?

5 replies

by mpdcsup

If you're mixing two different subnets on the same segment, you'll have to use a reservation, otherwise:

If you are setting up DHCP relay on the routers, everything should be ready to go.  A client on a remote network will send abroadcast for IP configuration on its local subnet.  The router on that subnet will pick up the request and forward it to the DHCP server.  The DHCP server will check the source IP of the forwarder (the router) and determine the appropriate scope to draw the resulting license from.

by luis

If the subnet is on the other side of a Cisco Router, then all you need to do is use the ip helper-address command on the Cisco Router. It will forward broadcast from the remote subnet to the DHCP-Server.

Syntax: ip helper-address x.x.x.x
where x.x.x.x is the ip address of your DHCP server.

This discussion is closed to new replies.