Discussion Locked

DHCP out of addresses again

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Our DHCP server is almost out of addresses for our network. We are setup as 192.1.1.x. We will be adding several new workstations/printers to the network in the next couple of weeks and will run out of addressing. How can we fix this? Can we subnet?If so, how?

3 replies

by barry hensley

I have to make some assumptions to give you an answer. I assume your subnet mask is 255.255.255.0 and that you have a single LAN, no routers, etc.

You can subnet but, that requires physically separating your network into 2 or more pieces dividedby a router or by installing multiple NICs in a server.

The simplest thing you can do without making any physical changes to your network is to increase the scope of your IP range and make the proper changes to your DHCP server.

If your subnet mask is 255.255.255.0, you can easily change it to 255.255.254.0, giving you the equivalent of 2 full class C's to work with. You will need to manually renumber any hosts with static addresses, DHCP will take care of the dynamically assigned addresses.

Using this mask, your IP address range would be: 192.1.0.1 - 192.1.1.254. The network address is 192.1.0.0 and the broadcast addresss is 192.1.1.255.

Any hosts with previously assigned addresses can keep their addresses and will work fine until their subnet masks have been updated. Make sure you consider what this impact will have on your firewall or internet router, etc.

This discussion is closed to new replies.