Discussion Locked

DHCP Superscope problem

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We are running out of addresses in our DHCP server. I intended on setting up supernetting but found out I needed to change all the static IP's before it would work right and there are too many right now. I then decided to try superscoping two scopesto get the additional addressing. The DHCP server seems to be fine and assignes the new addresses from the additional scope, but the workstations with the new address can't see the domain or PDC for authentication during logon. Am I missing something? How can we get the two subnets 192.1.1.x and 192.1.2.x to talk to each other? We tried playing around with the route tables but didn't seem to get it right. Any help would be greatly appreciated.

6 replies

by mgonzales

Make the subnet mask 255.255.0.0 and that will make both IP ranges on the same subnet....that will make 192.1. represent the network and balance of the IP's for Hosts...Hope this helps

Mike

by frobo

Hi,

quick and dirty:
1.) Add a second Ip-Adress to the Server?s Nic. Allow IP-routing !

2.) Now add the new Scope to your DHCP-Server. Add the Servers second IP-Adress as the default gateway.

With this solution you can migrate your wks to the new IP-Range, and solve the Server Side on a Weekend.

Hope it helps

Frobo

This discussion is closed to new replies.