Discussion Locked

DHCP with more than one scope

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a windows NT based network, with more than 50 workstations. Up to now the addressing scheme is dynamic provided by the PDC wich acts as a DHCP server and DHCP relay. We have also an ISDN line to connect to the Internet. Recently the company ordered a new type of Internet connection based on the ADSL technology. Our new ISP provided us with a new range of IP address that would not match the number of networked devices in the network. Also they provided us with a new preconfigured router.the old range of IP addresses is of course totally different (ie different IPs and different subnet mask.
The existing DHCP server has only one network interface card. I have been advised to configure the Server with more than one IP address and totake advantage of the Superscope configuration on the DHCP manager, but i am affraid it is not as simple as they have suggested. There is the issue of leases, subnet mak, default gateway and so on.
Another thing worth of mentionning is that the ISP kind of obliged me to give a certain IP address to the mail server which will make it just next to the router in the IP order.
Any suggestions? Could you please be specific in your answers.

Many thanks

9 replies

by kent.manley

I'm assuming all of your workstations are using routable IP addresses. Your best best is to implement some kind of Network Address Translation, leaving the routable adsl addresses outside and putting unroutable rfc 1918 addresses on the inside.

You can do this with MS Proxy Server (although I don't really recommend it), a device such as the Netscreen 10 (around $3500), or a Linux/BSD firewall/nat box.

What you would do is have a network setup like this:

Internet -> Router -> Mail Server -> Internal
NAT/Firewall Network

You can run DHCP on a server inside the firewall, giving you as many IP addresses as you need.

Feel free to contact me for more details.

Kent.manley@att.net

by barry hensley

You are going to need to configure your network with OFF-NET addresses and implement NAT.

In your current configuration, you don't have enough IP addresses and you don't have any security on your LAN.

I would recommend placing a NAT box between your LAN and the DSL router that your ISP provides. You can use something like the LinkSys BEFSR41 - EtherFast 4-Port Cable/DSL Router. It sells for less than $400 and does DHCP, NAT, etc. Connect this device to the DSL router using Ethernet cable. Place a hub on the segment between the LinkSys box and the DSL router and you have created a LAN in which to place your email server, etc. All devices on this LAN will have real IP addresses. All devices behind your LinkSys box will have off-net addresses and will be protected from the internet.

By the way, the DHCP on the LinkSys box provides up to 253 ip addresses. It's very easy to setup.

by Former member

Actually it sounds as though the Router provided by the carrier already handles NAT so in that router (which probably acts as a DHCP server) you would change the INSIDE ADDRESSes to your current scope! It's that easy. You can then disable DHCP on you NT Server..

by michael roark - ccna/da mcp 3csa

which kind of router are they giving you? you may want to go ahead and pull the papers on it. also, your mail server, am I correct in saying it's a regular POP3 server, you need to set that up separately, to allow mail to get passed the firewall andcome in, obviously. I too would suggest allowing the router to provide DHCP and NAT, but one note, routers can go down, just like the next device. Leave your DHCP service configured, but disabled, for ease of enabling, if you ever (hopefully not) needed to.
Good Luck.

This discussion is closed to new replies.