Discussion Locked

Diff. between Switch & Catalyst Switch

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Will somebody help me explaining difference between Switch & catalyst switch? Can somebody explain me difference between layer2 & layer3 switches?

7 replies

by ryttinch

The basic difference between layer 2 and layer 3 switches is that a layer 3 switch can handle some routing. And with a catalyst switch, you can actually purchase cards for routing, so you can have all of that functionality within the same environment.

by turambar386

"Catalyst" is a brand name of switch
manufactured by Cisco.

Layer 2 switches only act on the MAC address
of the NICs attached to each port to make
switching decisions.

Layer 3 switches have some routing abilities
and can make switching decisions based on the
network address.

Hope that helps.

by ckilday

devendra,
The Catalyst is actually a "family" of switches produced by Cisco. They come in a variety of models, sizes and capabilities. There are 1900, 2900, 3500, 5000 and 6000 series models and range from a simple 12 port unit to units that can support gigabit ethernet, ATM, routing modules and a couple of hundred users running 100Mb ethernet on copper or fiber. When connected together, the switches use spanning-tree protocol to prevent loops that can cause broadcast storms. The higherend models support what is known as "ether-channel" or the bonding of 2, 4 or 8 ports together and treating it as a single path for communication between switches. This works well for your "core" switches and server farms since you multiply the bandwidth available for transport between them.

As for the difference between layer 2 and layer 3 switching, the other respondents have defined it fairly succinctly, but perhaps an example might help. A layer 2 switch knows only about the MAC address that identifies each nic attached to its ports. A layer 3 switch can identify a device by its network address as well as the MAC address. Where this comes in handy is in a larger switch where you have a couple of VLANS. VLANS cannot communicate directly with each other because they are separated by their network address. Devices on different VLANS normally have to go through a router to communicate. This decreases response time, especially if both VLANS are on the same switch! With a layer 3 switch, the switch knows about both VLANS and their network addresses and if there is communication between the two, it switches between them without going through the router. Hope this helps.
- ck

This discussion is closed to new replies.