Discussion Locked

Direct Cable Networking

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a problem. I want to network a computer (Windows 98SE) and a laptop (Windows 2000 Professional) using a parallel cable for sharing files and printers. I already have a parallel cable and tried the connection but was not successful. I deleted all connections and want to try again but also want to make sure I'm doing it the right way. If you can help, please resond to this question. Thanks.

~Dave

7 replies

by pschuvie

What seems like the simplest thing often can be the most frustrating. Often the culprit is the cable, as it is not just a normal parallel cable but a very specific one that handles the commmunication functions not normally involved with a parallel (printer) cable.

Here is a great site for all information on how to do this and also how to trouble shoot it. www.lpt.com Yes they have a vested interest since they make the cable that this whole process seems to have been developed for. But it still has great information and how to.

Here is another site that has a wealth of networking information that might also be of assist. It has information about DCC and I just have not reviewed it all specifically.

Hope these are enough helpto get you up and running.

Of course never forget the Windows Knowledge Base as there are some specific issues with Windows 2000 that are addressed in various articles there.
I

by tbradley

Unless you want to go the LPT2 card and SwitchBox route, you would be better off to go down to your local computer gizmo place and get a null modem cable. ( Female to Female, 9 pin ) or DB9F to DB9F as they are marked.

This way, you are using one of your serial ports, and keeping the LPT port free for the printer cable.

( BTW, specialized parallel cables cost FAR more than a null modem cable, although you do have a speed advantage via parallel, but if all you want to do is share files and printers, you most likely wouldn't notice the difference )

by griswaldaus

If both machines have a network card, you could use a "crossover" cat5 cable. This will work the same way as if both machines were on a larger network. The null-modem cable requires software, while the crossover cable needs firmware. The choice is yours!

This discussion is closed to new replies.