Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm running 4.11 with intranetware SBE. I have nslp running and want ro disable sap & rip. I went into ipxcon but dont see were sap/rip can be disabled. Am I in the right place? Any suggestion? Thanks so much!
5 replies
by vita555
Hi!
On server console enter> load inetcfg
If you'll see "Add initialization commands to AUTOEXEC.NCF?" you should agree.
Next go to menu option "Binding" and
choice "IPX". Hereinafter find "Expert Bind Option" and choice it.
Now you can disable RIP & SAP or change their parameters. After all don't forget on console make command: Reinitialize system
If you have several NICs repeat this operation for each net. interface.
Regards, Vitaly
by collins_ms
The question was auto-closed by TechRepublic
by tom_pace
RIP ans SAP are configured per interface. Go to INETCFG and select the IPX binding for each interface you want to control. You will find the selection for RIPonly vs NLSP with RIP compatability there.
by collins_ms
The question was auto-closed by TechRepublic
by collins_ms
This question was auto closed due to inactivity
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies