The "official" distance between any two devices is 100 meters, or roughly 300 Feet. There are several factors which come into play than can decrease or increase this distance.
First is the quality of your wiring. There is Cat 5 and then there is Cat 5. If your wiring is right up to spec, away from electrical interference, terminated properly, installed with no kinks or tight bends, not pulled too hard during the install you should be able to go quite a bit over the 100M recommendation.Second is the speed of your communications. 100Mbps requires tighter wiring specs than 10Mbps and is more prone to failure. If your wiring is up to spec as mentioned above, this will not have much of an effect. But my experience is that wiring israrely all the way up to spec, so this is worth some consideration.
Third is the duplex setting. Full duplex is much more forgiving of distance. Because the two devices do not need to take turns, they are less likely to suffer data loss due to the distance/timing constraints of half duplex communications.
One other thing that deserves mention. If you are running switch to switch, hub to hub, hub to switch, you probably need a cross over cable where the 1/2 and 3/6 pairs are switched oneach end of the wire. Some devices have a setting to eliminate the cross over need, so make sure you check.
If you need to go significantly over the 100M limit, consider fiber. The costs have decreased quite a bit and distance constraints aremeasured in 1000's of meters on even the lowest grades of fibers. Media converters for your switches/hubs are only a couple of hundred dollars. If you can find someone who knows what they are doing, installation may be fairly reasonable as well.
I hope this helps. Good luck.
Dan