Through the years my box/bag of tools has changed as my job responsibilities have changed. I now have different tool boxes that I use depending on the job I am on. There are a lot of duplicate items between the two, however each has special items.
For example, if I am running wire then I have my kit with the crimps and ends, Tone Generator and sniffer. This kit also holds my Fluke, nice piece of equipment if you have the need for one and you know how to use it properly, but if you don?t, then save your money.
I used to carry a BNC crimp and ends but have tossed then after I figured I had not used them in nearly 7 years.
I know some will say that to have everything in one kit is better because you are always prepared in any case. Well true, but with the same logic, why not include every tool I have in my very large tool box. There are times I need a socket, and I have small little kits, again different bag for the jobs that call for them. I may take different ones in the car just incase. But when you are hauling around all the weight you will learn to take what you need. And if you don?t have you will just have to go get it.
Like the time I needed a hammer to fix a computer. Don?t carry one but needed it. Good thing was the client had one and let me use it.
Why did I need a hammer you ask? Well the computer in question that was shipped to them was, shall we say, not packaged properly. The box was dropped of the back of the truck and one of the corners on the case bent over so much that one could not remove the lid. The system would not power up and I needed to look inside to see what had been jarred loose when it collided with the pavement. The hammer was the only thing short of a cutting torch that was going to get it open. Once I hammered the case into shape I was able to asses the internals, reset the memory that had been knocked completely out along with several of the cards. Once that was done the system came to life. How the hard drive survived?
One think I did not see on the list or put forth in the comments was a mechanical pencil.
The larger ones are great for straitening out bent pins on all different types of connectors. Needle nose pliers are not the answer for this. And the smaller ones work on several of the different types of SCSI cables.
A bit of advice, for those that are starting up and making your kits, If you have any of those kits that they like to hand out for free, take my advice open it up and take all the screw drivers out and throw them away. Go get yourself some good ones. I use craftsmen, cheep and good for the most part. When it comes to the Philips Screwdrivers make sure you get a #2 Philips, most are not aware that the ones included in the free kits are not Phillips but a Reed and Prince AKA as a Fearson. These are the biggest culprits for reaming out Phillip screw heads. http://en.wikipedia.org/wiki/Image:Frearson_vs_Phillips.svg