Discussion Locked

Drive Mirroring

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am using Novell 4.11 on a Compaq Prosigna 200 server. I want to add an IDE disk and set up a duplex/mirror on the server. I attached the second drive to the secondary onboard IED controller but when I go to install it shows both drives but won't let me mirror them. When I check the mirror it shows "not mirrored" but when I look at each drive it shows "In Sync". What am I doing wrong?

2 replies

by jimbb

They are "in sync" with themselves, so you shouldn't worry about that.
Why doesn't it let you mirror them? Any message indicating something?
By the way, you should have at least the same number of blocks, or more, on the second drive. Have you verified this?

Jim

by mark

Is it a blank Hard Disk? You need to delete all the partitions on it and create a Netware partition that is at least as big as what you want to mirror. Then press "INS" to add it as a mirror to the other HD.

This discussion is closed to new replies.