Discussion Locked

DSL Extension, how and with what?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a PacBell DSL and I want to extend it to my garage office. About 75 to 80 feet.
What wire. Simple hub or something expensive like LinkSys. Software issues. Other connectivity issues. I have already been given advice from the simple to the complex.
What did or would you do???

5 replies

by saephraim

If you are just running one pc, then just run the line from your DSL Modem to your pc in the garage...

but I'm assuming you are running 2 or more pcs and you want them both to have internet access...

First, find out if PacBell will let you lease more then one public ip address (you will need one for each pc.) If they will, then a simple powered hub will work fine.

If they will let you only have one public IP address, then you will need to purchase something similar to the linksys DSLRouter will use NAT, allowing you to use 1 public internet IP address for multiple pcs.

by barry hensley

The digital signal that arrives at your DSL modem gets converted into 10BaseT Ethernet before connecting to you PC. You can run 10BaseT ethernet over several types of wires, the most common being what is known as Category 5. You will need a suitablelength of Cat 5 wire (22 gauge, 8 solid conductors) to run from your DSL modem to the new location. You can also use your existing phone wires in the house for 10BaseT but it requires at least 2 pairs and is usually not as reliable.

Once you havethe wire run, you need to terminate on suitable jacks. Pick up a couple of 8 conductor 10BaseT surface or wall mount RJ-45 jacks at your local Fry's or Radio Shack. Terminate the new wire on these jacks placing one pair from the Cat 5 on each of thefollowing pins: 1-2, 3-6, 4-5, 7-8. Use the same pairs and color coding on each end. Connect a common Cat 5 Ethernet patch cable from the RJ-45 on one end to your PC and from the RJ-45 on the other end to your DSL modem and you should be in business.

Like the previous answer, if you need to connect more than one PC, use an inexpensive powered 10BaseT hub (about $50) to connect multiple PC's to a DSL router that provides NAT functionality (most of them do). Connect the DSL router to your DSL modem and you're in business. Also, most DSL routers have a 4 port hub built in.

This discussion is closed to new replies.